Plotting help
-
I just ran a the mdcct plotter on a 3 TB hard drive but the process says it was killed after a couple of hours of processing? Why did that happen? Did I run out of memory? Can I restart where I left off?
This is what my terminal says:
root@cd4c836402f5:/mnt/disk2-3TB# plot -k 145xxxxxxxxxxx82820 -x 1 -d ./ -a Async mode set. Using SSE2 core. Creating plots for nonces 851589091774395047 to 851589091785422627 (2892 GB) using 15982 MB memory and 1 threads 0 Percent done. 610 nonces/minute, 300:25 leftKilled root@cd4c836402f5:/mnt/disk2-3TB#
-
this can happen if you use too much RAM. Try to lower -m.
-k [BURST NUMERIC ADDRESS] -d [DIRECTORY] -s [START] -n [HOW MUCH SPACE] -m [RAM] -t [NUMBER OF CPUS]
-
I'm trying now without the
-a
because that doubles the memory usage.